POW2087
EN
Copyright © 2015 VARO
P a g e
|
8
www.varo.com
8.1
Switching on / off
Attention! Before working with the angle grinder, check that the voltage
shown on the machine’s model plate is the same as the mains voltage
being used. Before engage the ON/OFF switch trigger, check that the
grinding disc is properly fitted and run smoothly, the outer flange is well
tightened.
8.1.1
Switching on (Fig. D)
Insert the plug into a correctly installed mains socket.
Push forward the ON / OFF switch with safety button (5) (See the arrow (1) on Fig. 10),
and at the same time depress it firmly inwards and keep it pressed (See the arrow (2)).
8.1.2
Switching off
When you release the switch, the tool turns off.
Do not let go of grinder until it has stopped running.
Warning: The wheel continues to rotate after the tool is switched off.
9 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
9.1
Cleaning
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
Regularly clean the machine housing with a soft cloth, preferably after each use.
Keep the ventilation slots free from dust and dirt.
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
9.2
Lubrication
The machine requires no additional lubrication
10 FAULTS
Should a fault occur e.g. wear of a part, please contact your local Power plus dealer.
11 TECHNICAL DATA
Voltage / frequency
230-240 V / 50 Hz
Power input
2150 W
No-load speed
6500 min
-1
Disc diameter
230 mm
Spindle dimension
M14
Weight
4.65 kg