Powermatic 201, Instruction Manual And Parts List

Page: 4 / 40

4
!
SAFETY RULES
As with all machines, there is a certain amount of hazard involved with the use of this planer. Use the machine with
the respect and caution demanded where safety precautions are concerned. When normal safety precautions are
overlooked or ignored, personal injury to the operator can result.
Read, understand and follow the safety and operating instructions found in this manual. Know the limitations and
hazards associated with this planer.
Electrical grounding. Make certain that the machine frame is electrically grounded and that a ground lead is
included in the incoming electrical service. In cases where a cord and plug are used, make certain that the
grounding plug connects to a suitable ground. Follow the grounding procedure indicated in the National Electrical
Code.
Eye safety. Wear an approved safety shield, goggles, or glasses to protect eyes. (NOTE: Common eyeglasses
are only impact-resistant, they are not safety glasses.)
Personal protection. Before operating the machine, remove tie, rings, watch and other jewelry and roll up sleeves
above the elbows. Remove all loose outer clothing and confine long hair. Protective type footwear should be used.
Where the noise exceeds the level of exposure allowed in Section 1910.95 of the OSHA Regulations, use hearing
protective devices. Do not wear gloves.
Guards. Keep the machine guards in place for every operation for which they can be used. If any guards are
removed for maintenance, DO NOT OPERATE the machine until the guards are reinstalled.
Work area. Keep the floor around the machine clean and free of scrap material, saw dust, oil and other liquids to
minimize the danger of tripping or slipping. Be sure the table is free of all scrap, foreign material and tools before
starting to cut. Make certain the work area is well lighted and that a proper exhaust system is used to minimize dust.
Powermatic recommends the use of anti-skid floor strips on the floor area where the operator normally stands and
that each machine’s work area be marked off. Provide adequate work space around the machine.
Avoid accidental starting: Make certain motor switch is in off position before connecting power to the planer.
Operator position. Maintain a balanced stance and keep your body under control at all times. Stand to the left
side out of line with the table and make sure no one else is standing in line with the table.
Housekeeping. Before turning on machine, remove all extra equipment such as keys, wrenches, scrap, and
cleaning rags away from the machine
Careless acts. Give the work you are doing your undivided attention. Looking around, carrying on a conversation,
and “horseplay” are careless acts that can result in serious injury.
Disconnect machine before performing any service or maintenance or when changing blades. A machine under
repair should be RED TAGGED to show it should not be used until the maintenance is complete.
Maintain tools in top condition. Keep tools sharp and clean for safe and best performance. Dull tools increase
noise levels and can cause kickbacks and glazed surfaces. Broken tools or tools that are not securely locked in the
cutterhead can be thrown out of the planer causing severe or fatal injury as well as severe damage to the machine.
Check the condition and adjustment of the tools before making any cuts. Follow the sharpening instructions on knife
grinding and jointing, installing and adjustments.
Short stock: Do not attempt to plane boards shorter than 12" (305mm) in length without butting a board of equal
thickness behind it to help it through the planer. Be sure the last board of a butted sequence is 12" (305mm) long or
longer.
Stacked boards: Do not feed stacked boards through a planer; a kickback can occur causing severe or fatal injury.