7
Read and understand the
entire contents of this manual before attempting
assembly or operation. Failure to comply may
cause serious injury.
5.0
Setup and assembly
5.1
Unpacking
Remove all items from the pallet and inspect for
damage. If any is discovered, contact your
distributor. NOTE: Remove 2 screws holding the
drum to the pallet. There may be additional
fasteners securing items to the pallet.
Remove all items from their separate
boxes/packages and compare to the contents list in
this manual. If any part shortages are identified,
contact your distributor. Do not discard boxes or
packing material until dust collector is assembled
and running satisfactorily.
The letter designations below are used throughout
the assembly instructions.
5.2
Shipping contents
(Figure 5-1)
1 Main housing with filter – A
1 Base – B
1 Upper drum – C
1 Lower drum – D
1 Drum lid – E
1 Inlet adaptor – F
1 Support frame – G
1 Right stand panel – H
1 Left stand panel – I
1 Hose – J
2 Hose 2in. – K
2 Hose clamps – L
1 Cone clamp – M
1 Canister bag clamp – N
1 Drum handle – O
1 Reducing cone – P
1 Quick lever – Q
2 Fixed casters Ø3 x 1-1/4 – R
2 Swivel casters Ø3 x 1-1/4 – S
4 Drum casters – T
1 PE bag, large (for drum) – U
1 Drum clamp – V
1 Roll foam tape, 3/4x50L (20x1265mm) – FT3/4
2 Rolls foam tape, 1x38L in. (30x970mm) – FT138
2 Quick connectors – A1
4 Hose clamps 2” dia. – B1
1 PE bag, small (for canister) – C1
1 Remote
control
(with 2 AA batteries)
– RC
4 Angle supports – E1
1 Roll foam tape, 1x25L in. (30x640mm) – FT125
Figure 5-1: contents (not to scale)
Hardware package, #PM2200-HP-1
(Figure 5-2)
16 Hex flange head screws, 5/16x1/2 – HP1
55 Button head screws, 5/16x3/4 – HP2
55 Flat washers, M8 – HP3
2 Phillips pan head screws, 1/4x1/2 – HP4
8 Button head screws, M5x10 – HP5
1 Open end wrench, 10/12mm – HP6
2 Hex keys, 4mm and 5mm – HP7
Figure 5-2: #
PM2200-HP-1
hardware package
contents (not to scale)
