PowerLand PD210E, Owner'S Manual, Page: 10 / 36

6
Oil Alert System
The Oil Alert System is designed to prevent engine damage caused by an insufficient of oil in the
crankcase. Before the oil level in the crankcase can fall below a safe limit, the oil alert system will
automatically stop the engine (the engine switch will remain in the
ON position). If the engine stops
and will not restart, check the engine oil level before troubleshooting in other areas.
DC Receptacle
The DC receptacle may ONLY be used for charging 12 volt automotive type batteries.
The battery must be connected to the generator DC receptacle with the proper polarity (battery
positive to generator positive (+) and battery negative to the generator negative (-)).
WARNING:
Do not start the vehicle while the battery charging cable is connected and the generator is running.
The vehicle or the generator may be damaged.
AC/DC (Weld) Selector Switch
The AC/DC (Weld) selector switch is located on the control panel.
g
To avoid accidental arcing, one cable end should be firmly attached
to the object to be welded, and the electrode holder at the end of the
other cable should be held in the operator's hand. DC voltage is
present at the welding terminals at all times, regardless of the
position of the AC/DC(WELD) selector.
g
Under no circumstances should any type of electrical appliance be
plugged into any of the AC receptacles when the selector is in the DC (WELD) position. AC voltage
is present at the AC receptacle at all times, regardless of the position of the AC/DC (WELD) selector.
However, when this selector is in the DC (WELD) position, the AC voltage is unregulated and
fluctuates considerably.