Installation / Initial Set-
Up (cont’d)
20
7. Battery Installation
Your generator's engine is equipped with an electric starter, which requires the installation of a 12-volt battery.
See the "Specifications" section of this manual for more specific battery requirements for this generator model,
such as minimum amperage or CCA rating.
The battery is to be supplied by the customer and should be installed in the protective battery tray located
near the engine. The orientation of the battery should be with the tabs to the front. Follow the instructions
detailed below for connecting and disconnecting the battery.
WARNING: Battery hazards
Batteries are hazardous because they contain caustic acid, can emit explosive gases, and can cause
electric shock. Caution must be exercised when making connections to a battery to avoid shock and
contact with the acid, and to prevent any sparking that could lead to an explosion.
ALWAYS follow the general battery safety rules and instructions listed below.
General Battery Safety Rules
•
ALWAYS use eye protection when handling batteries.
•
NEVER smoke or work near sparks or other sources of ignition.
•
NEVER touch both battery terminals at the same time with your hand or any non-insulated tools.
If battery acid contacts skin or clothing, flush immediately with water and neutralize with baking soda.
Always connect the cables in the following sequence to avoid possible shock:
Connecting the battery
1. Find the battery cables located inside the battery box.
2. Connect the
red
cable to the
positive
(+)
terminal of the battery.
3. Then connect the
black
cable to the
negative
(-)
terminal of the battery.
Disconnecting the battery
1. First, disconnect the
black
cable from the
negative
(-)
terminal of the battery.
2. Next, disconnect the
red
cable from the
positive
(+)
terminal of the battery.
Battery tabs
Battery tray
