Powercore
PLUS Desk
Resetting your desk
Powercore desks need to be reset after assembly and
prior to use. Follow these steps:
1.
Press and hold down both the up arrows and down
arrows simultaneously for 7 full seconds until the
desk starts moving down.
2.
Keep the buttons pressed all the way to the bottom.
(The screen will show E00 just before it reaches the
bottom).
3.
When it reaches the bottom it will “beep” and reset.
When it “beeps” you can release the buttons and it
should show the height of the desk. The desk is
ready to go.
If the screen shows E00 and doesn’t beep, the reset
hasn’t been completed properly so you need to repeat
the process.
When the desk goes to it’s lowest level it is because the
sensors are telling the controller that the desk is possibly
uneven and needs to be leveled at it’s bottom height.
Manually adjusting the height
Simply press the “up” or “down” arrows to go to your
required height.
Setting automatic height adjustment
If you want to use the memory function to automatically
move to preset heights, follow these steps:
1.
Move the desk to the height you want to assign
a preset memory number to.
2.
Press “M” and hold it down until the screen starts
flashing. Release the “M’ button and select the
number you want to allocate that height to
(1, 2, 3 or 4).
3.
When the P- (number allocated) shows on the
screen - you have successfully allocated that
preset (1, 2, 3 or 4) to the height.
4.
Move the desk to another height level and repeat
the procedure to other preset numbers (1,2,3 or 4)
To move the desk to a preset height level just press
the number (1,2,3 or 4) and release. The desk will
move to that preset height.
You can overwrite these settings any time by
repeating the process and re-allocating the preset
number to a different height.
Error messages
If the handset on the desk shows an error message
(E - “number”) it is a good chance the desk just
needs a reset. Follow the instructions at the top of
this page.
If the error message persists (despite the reset):
email
with the error
message and I’ll get in contact to help you. Most
solutions are pretty simple.
Here’s the low down on your desk and how to set it up.
Watch the assembly video:
vimeo.com/371500187
Enjoy your desk
and your mobility
powercore.nz
Powercore_assembly instructions_Plus desk_A4.indd 1
Powercore_assembly instructions_Plus desk_A4.indd 1
11/05/22 2:25 PM
11/05/22 2:25 PM
