Power2max NGeco, Manual

Page: 21 / 84

Operation and installation
IMPORTAnT:
It is necessary to observe indicated torque values during installation. you can also find these
values in the download area of power2max.com. Screw and bolt connections that are torqued too
heavily or weakly could damage the power meter and impair the function.
In the case of bicycle frames with a BB86 or BB386EVO bottom bracket standard, the compatibili-
ty between the power meter and frame must be tested before installation.
nECESSARy TOOLS
• In the case of models with lockrings like FSA BB386evo, a specific lockringtool for instal-
ling the crankset to the power2max NG
eco
power meter is needed.
• Depending on the model: medium-strength threadlock (e.g. Loctite 243).
• Optional: bench vice to fixate the lockring tool during installation.
OPERATIOn
Your power2max NG
eco
power meter has an LED indicator light to control its function. This
enables you to easily test functionality and operate the system in a quick and uncomplicated
way.
Step 1
Remove the isolation strap by pulling it out of the battery compartment. Check if the
battery cap is in the correct position.
Step 2
Now, the LED indicator light flashes green for approximately one minute.
Step 3
Connect the power meter to your head unit (observe manufacturer’s instructions). As long
as the green LED indicator light blinks, the power2max NG
eco
power meter is emitting
signals that can be received by an ANT+ or Bluetooth enabled head unit. Pair your power
meter-compatible head unit with your power2max NG
eco
power meter. Observe the respec-
tive manufacturer’s manual. Pairing your head unit is only necessary when operating the
power meter for the first time. Numerous power2max NG
eco
power meters on different
bicycles should be put into operation one after another to avoid unwanted connections
between different power2max NG
eco
power meters and head units.
You can repeat the pairing of your ANT+ or Bluetooth enabled head unit at any time. To do
so, you just have to activate your power2max NG
eco
power meter by turning the crankarm.
Your power2max NG
eco
power meter then signalizes its availability for pairing by blinking
its green LED indicator light for one minute.
hier stehen andere
Informationen als
in der deutschen
Fassung!
p
ow
e
r
2
m
a
x
NG
E
co
21
E
n
g
l
ish