CAUTION
Inspect the filter in the water inlet connector before
you connect the garden hose
• If the filter is damaged, do not use the machine
until the filter is replaced.
• If the filter is dirty, clean the filter.
Figure 5.
1. Uncoil the garden hose.
2. Let the water flow through the garden hose for 30
seconds.
3. Turn the water supply off.
4. Install and tighten the end of the garden hose to the
water inlet connector.
CAUTION
There must be a minimum of 3 m of free hose
between the water inlet and the water supply.
3.4.2 INSTALL THE BUCKET
Figure 6 - 7.
1. Add water to the bucket.
2. Align the water inlet connector with the water inlet.
3. Install the bucket onto the base.
4. Lift and push down the bucket buckle to fix the
bucket.
WARNING
Pull the bucket buckle to unlock the bucket.
3.5
INSTALL THE BATTERY PACK
Figure 8.
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the engine stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Open the battery door.
2. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
3. Push the battery pack into the battery compartment
until the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door.
3.6
REMOVE THE BATTERY PACK
Figure 8.
1. Open the battery door.
2. Push and hold the battery release button.
3. Remove the battery pack from the machine.
4
OPERATION
WARNING
Make sure that all the connections are tight and have
no leakage before operation.
4.1
USE THE GUN
Figure 3.
WARNING
For safe control, keep your hands on the gun at all
times.
• Pull and hold the gun trigger to start the machine.
• Release the gun trigger to stop water flow through
the nozzle.
4.1.1 UNLOCK THE GUN TRIGGER
• Push backward the trigger safety button.
4.1.2 LOCK THE GUN TRIGGER
• Push forward the trigger safety button.
4.2
INSTALL THE NOZZLE
Figure 9.
WARNING
Before you change the nozzle:
1. Pull the gun trigger to release water pressure.
2. Lock the trigger safety button on the gun.
3. Stop the mahcine.
WARNING
Do not point the spray wand at your face or others'.
1. Push and hold the lock button on the spray wand.
2. Align the pin on the nozzle with the hole on the
spray wand.
3. Install the nozzle onto the spray wand.
4. Rotate the nozzle to adjust the spray shape.
4.3
INSTALL THE DETERGENT TANK
Figure 11 - 12
.
6
English
EN
