POWXG2061
EN
Copyright © 2017 VARO
P a g e
|
7
www.varo.com
See instructions under the heading Start. Start the machine and apply full throttle. Release
the throttle and check that the cutting attachment stops and remains at a standstill. If the
cutting attachment rotates with the throttle in the idle position then the carburetor idle
setting must be checked. (Fig. 4)
8.2
Engine switch (Fig. 5)
Press down the “O” side of the engine switch to stop the engine.
Start the engine and make sure the engine stops when you move the engine switch to the stop
setting.
8.3
Vibration damping system (Fig. 6)
Your machine is equipped with a vibration damping system that is designed to minimize
vibration and make operation easier.
Using incorrectly wound cord or a blunt or incorrect cutting attachment (wrong type or
incorrectly filed, see instructions under the heading Filing the blade) increases the level of
vibration.
The machine′s vibration damping system reduces the transfer of vibration between the engine
unit/cutting equipment and the machine′s handle unit.
Regularly check the vibration damping units for cracks or deformation.
Check that the vibration damping element is undamaged and securely attached.
8.4
Quick release
There is an easily accessible, quick release fitted near the suspension ring as a safety
precaution in case the engine catches fire, or in any other situation that requires you to free
yourself from the machine.
8.5
Muffler
The muffler is designed to keep noise levels to a minimum and to direct exhaust fumes away
from the user.
Never use a machine that has a faulty muffler.
Regularly check that the muffler is securely attached to the machine.
The inside of the muffler contain chemicals that may be carcinogenic. Avoid
contact with these elements in the event of a damaged muffler.
Bear in mind that: The exhaust fumes from the engine are hot and may
contain sparks which can start a fire. Never start the machine indoors or
near combustible material!
9 OPERATING INSTRUCTIONS
9.1
Prepare the machine
9.1.1
Assembling the front handle
Fit the front handle absorber (A) on the rear tube (C). Fit the barrier on the rear handle. Make
sure the barrier on the left side of the machine. (Fig. 8)
Push down the front handle (G), and then turn four screws (H) clockwise to tighten the front
handle securely. (Fig. 9)
