POWPG10240
EN
Copyright © 2019 VARO
P a g e
|
10
www.varo.com
Clean underside of deck. Be certain to clean the underside of the cutting deck after each use
to avoid a build-up of grass, which would prevent proper mulching. Mowing leaves. The
mowing of leaves can also be beneficial to your lawn. When mowing leaves make sure they
are dry and are not laying too thick on the lawn.
Do not wait for all the leaves to be off the trees before you mow.
WARNING: if you strike a foreign object, stop the engine and wait until
cutting device has come to a complete standstill. Thoroughly inspect the
mower for any damage and repair the damage before restarting and
operating the mower. Extensive vibration of the mower during operation is
an indication of damage. The unit should be promptly inspected and
repaired.
10.2
Grass catcher (5)
There is a window on the rear cover. (Fig 8) You can see the condition of grass catcher
through the window. If the catcher is full of grass, you will empty and clean the bag, make sure
it is clean and ensure its meshwork is ventilated.
10.3
Height adjustment instructions (Fig 3)
CAUTION: Do not at any time make any adjustment to lawnmower without
first stopping the engine and waiting until cutting device has come to a
complete standstill.
CAUTION: before changing mowing height, stop mower and wait until
cutting device has come to a complete standstill.
Your mower is equipped with a central height adjustment lever offering 7 height positions.
▪
Stop mower and wait until cutting device has come to a complete standstill before
changing mower cutting height.
▪
The central height adjustment lever offers you 7 different height positions.
▪
To change the height of cut, squeeze adjuster lever toward the wheel, moving up or down
to selected height.
▪
All wheels will be in the same height of cut.
11 BLADE
The blade is made of pressed steel. It will be necessary to reshape it frequently(with a grind
wheel).
Ensure that it is always balanced (an unbalanced blade will cause dangerous vibrations). To
check for balance, insert a round rod through the central hole and support the blade
horizontally. A balance blade will remain horizontal. If the blade is not balanced the heavy end
will rotate downwards. Reshape the heavy end until the blade is currently balanced. To
remove the blade, unscrew the blade screw.
Check the conditions of the fan, and replace any parts, which are damaged.
When reassembling, make sure that the cutting edges face in the direction of the motor
rotation. The blade screw must be torque to 25NM.
