Power One PODS 16.48-16000 1940 HEX, Instruction Manual, Page: 62 / 170

9-2 PODS 16.48-16000 1940 HEX
Document number: 036972.fm
Revision: B
Product Description FMP 16
9.1 General - Product description FMP 16
The FMP 16 rectifier module is a modular power supply designed for parallel operation and plug-in
installation in the PPS 16 systems. The rectifiers provides extremely reliable DC power in the highest
possible density. The module incorporates the latest in power monitoring solutions through an internal
microprocessor, giving up to the second updates to the system controller and adjacent rectifiers,
guaranteeing tightly controlled load sharing among rectifiers, and providing status and identification
information to the controller.
There is no cabling at the front of the unit. The AC input, DC output and signal cables are connected using
a backplane integral to the cabinet frame. A rectifier module can be plugged into, or unplugged from, the
support frame with no impact upon the other modules.
The rectifiers operate on the principle of active load sharing and can operate in parallel. They incorporate
"soft start" at the input and at the output, which avoids high incoming and outgoing currents. The output
voltage of the rectifier is automatically adjusted to the required voltage at installation by the controller.
The rectifiers in the system are controlled by the controller, see chapter 8, Operation / Product description
PCS 2.
9.2 Technical specification
9.2.1 Mains input
Input voltage:100-240V AC +/-15% single phase
Input current:<10A
Frequency:44-66 Hz
Power factor:> 0,98 typical
9.2.2 DC output
9.2.2.1 Mains input 185-250VAC
Voltage:45V DC - 56 V DC nominal
Current limit:32A
Power:1600W
Efficiency:>93%, typical 93,5% (at 40-90% load)
9.2.2.2 Mains input 95-185VAC
Voltage:45V DC - 56 V DC nominal
Current limit:27A
Power:675W
Efficiency:>88,5%, typical 90% (at 40-90% load)
9.2.3 Module dimensions
Height:177 mm
Width:51 mm
Depth:280 mm
9.2.4 Weight
Approximately 2,2 kg