Power One PODS 16.48-16000 1940 HEX, Instruction Manual, Page: 42 / 170

7-2 PODS 16.48-16000 1940 HEX
Document number: 036285.fm
Revision: B
Commissioning
7.1 Commissioning Overview
Before delivery the system was thoroughly inspected and tested. The following chapter is a guide to the
set-up and operation of the control functions of the system.
Note! Before starting commissioning read the product description for the individual components.
If there are any difficulties in increasing the voltage to alarm level, the alarm level can be adjusted to a
lower level.
7.2 Tools and Test Equipment
7.2.1 Tools List
The essential commissioning tools are listed below:
z
A PC with PowCom installed (when controller is without LCD Display)
z
Anti-static hand strap
z
Socket wrench, insulated
z
Screwdriver set, flat, insulated
z
Screwdriver set, torx, insulated
z
Screwdrivers, pozidrive (cross head), sizes 1, 2, and 3, insulated
z
Torque spanner (for battery connection), insulated
7.2.2 Test Equipment
z
Multimeter (3 ½ Digit, 0 – 1% DC)
z
Load resistance, to connect 0-100% of total capacity to the system
7.3 Preparation
Check the installation to ensure the following:
z
Site is clean and safe
z
Grounding: The equipment is correctly grounded. The grounding cable size, color and routing
conform to the requirements
z
Power: The incoming mains AC power is available for this site. The site power switch and circuit
breakers are clearly labelled. The power cables are correctly terminated
WARNING! ONLY TECHNICAL STAFF WITH THE NECESSARY EXPERIENCE
AND KNOWLEDGE, WITH REGARD TO THE POWER SUPPLY SUPPORT SYSTEM
AND ITS BATTERIES, MAY PERFORM THE COMMISSIONING. IT IS IMPORTANT
TO FOLLOW ALL SAFETY REGULATIONS.