Power One PODS 16.48-16000 1940 HEX, Instruction Manual, Page: 31 / 170

Installation guide 6-5
Document number: 039160.fm
Revision: A
Installation guide
Figure 6-1 Base and cabinet mounting (empty cabinet shown)
After mounting the cabinet base and cabinet, the four lifting brackets mounted on top of the system should
be removed. The bolt holding the bracket should also be mounted in the opposite direction to tighten the
holes and make the top spill-proof. Figure
Figure 6-2 on page 6-6 shows the mounting of the brackets as
delivered, and also how the parts should be assembled after removing the brackets.
Follow these steps to correctly remove and reassemble the parts:
1. Remove the top lid from the cabinet for easy access.
2. Loosen and remove the top nut, then remove the washer and lifting bracket. Keep these parts for
possible future relocation of the cabinet.
Note! Only the nut and washer on top of the lifting bracket should be removed.
3. Enter the bolt in the opposite direction and fasten it from the inside with the remaining nut and
washer as shown in Figure 6-2 on page 6-6 .
4. Slide the top lid back into position on top of the cabinet.