Power One PODS 16.48-16000 1940 HEX, Instruction Manual, Page: 168 / 170

J-6 PODS 16.48-16000 1940 HEX
Document number: 039248.fm
Revision: B
Customer AC service outlet - Installation procedure
J.3 AC Power source requirements
Failure to observe the above warning may result in hazardous conditions on the system that may cause
injury to personnel.
J.4 Overview AC outlet
The AC service outlet is not provided by Power-One, but may be installed by the customer following these
instructions.
J.5 Installation and connection
1. Turn off the mains input voltage.
2. Remove the end stop piece mounted on the DIN rail below the mains terminal blocks.
3. Mount the AC service outlet by snapping the holder on the DIN rail below the mains input terminal
blocks. Mount the end stop below the AC outlet kit in order to prevent the parts from sliding on the DIN rail.
Note! If Surge arrestor kit or battery heater kit is installed, mount the AC outlet below the surge arrestor
and battery heater breakers as shown in Figure J-2 .
WARNING! HIGH LEAKAGE CURRENT. ENSURE EARTH IS CONNECTED
BEFORE CONNECTING MAINS SUPPLY
WARNING! PRIOR TO INSTALLING MAINS CABLING, ENSURE THAT THE
SYSTEM IS ISOLATED FROM ALL AC MAINS SUPPLIES.
WARNING! ONLY A QUALIFIED ELECTRICIAN MAY CARRY OUT THE
INSTALLATION.