Power One PODS 16.48-16000 1940 HEX, Instruction Manual, Page: 139 / 170

FMP 16 Dummy Module - Installation procedure G-5
Document number: 038471.fm
Revision: B
FMP 16 Dummy Module - Installation procedure
G.1 Scope and purpose
The purpose of this document is to give a clear instruction in the mounting of the FMP 16 dummy module in
the PPS 16.48 system.
Note! Use insulated tools with torque control.
Bits needed: Philips 2.
G.2 Safety precautions
It is possible to mechanically damage the units. To avoid this you must follow the approved assembly and
installation methods described in the relevant sections.
G.3 AC Power source requirements
Failure to observe the above warning may result in hazardous conditions on the system that may cause
injury to personnel.
WARNING! ONLY TECHNICAL STAFF WITH THE NECESSARY EXPERIENCE
AND KNOWLEDGE, WITH REGARD TO THE POWER SUPPLY SUPPORT SYSTEM
AND ITS BATTERIES, WHO HAVE COMPLETED THE APPROVED TRAINING TO
THIS SYSTEM INSTALLATION MAY CARRY OUT THIS INSTALLATION. IT IS
IMPORTANT TO FOLLOW ALL SAFETY REGULATIONS.
CAUTION! Care must be taken when installing this system. The units can be
damaged and can cause damage if not handled with care. Pay particular attention
to the order in which units are installed.
WARNING! HIGH LEAKAGE CURRENT. ENSURE EARTH IS CONNECTED
BEFORE CONNECTING MAINS SUPPLY
WARNING! PRIOR TO INSTALLING MAINS CABLING, ENSURE THAT THE
SYSTEM IS ISOLATED FROM ALL AC MAINS SUPPLIES.
WARNING! ONLY A QUALIFIED ELECTRICIAN MAY CARRY OUT THE
INSTALLATION.