Power One PODS 16.48-16000 1940 HEX, Instruction Manual, Page: 103 / 170

BTS Breaker 50A 3-pole - Installation procedure D-5
Document number: 038316.fm
Revision: B
BTS Breaker 50A 3-pole - Installation procedure
D.1 Scope and purpose
The purpose of this document is to give a clear instruction in the mounting of the 50A 3-pole load breaker
(upgrade kit) in the PPS 16.48-16000.
This breaker can be mounted with 50A, 100A or 150A load capacity.
WARNING! THE READER MUST READ AND UNDERSTAND THE WARNINGS AND CAUTIONS
IN THIS MANUAL BEFORE STARTING.
Note! Use insulated tools with torque control.
Bits needed: Flat 0,8x4x150, 13mm metric socket and PZ2.
Figure D-1 Insulated tools.
D.2 Safety precautions
WARNING! MAKE SURE THAT THE POWER TO THE SYSTEM IS
DISCONNECTED BEFORE STARTING THE INSTALLATION.
WARNING! ONLY TECHNICAL STAFF WITH THE NECESSARY EXPERIENCE
AND KNOWLEDGE, WITH REGARD TO THE POWER SUPPLY SUPPORT SYSTEM
AND ITS BATTERIES, WHO HAVE COMPLETED THE APPROVED TRAINING TO
THIS SYSTEM INSTALLATION MAY CARRY OUT THIS INSTALLATION. IT IS
IMPORTANT TO FOLLOW ALL SAFETY REGULATIONS.
CAUTION! Care must be taken when installing this system. The units can be
damaged and can cause damage if not handled with care. Pay particular attention
to the order in which units are installed.