Page 67 of 89
(PVI-6000-OUTD-xx-AU Rev:1.0)
An arrow on left side of the display highlihghts your current selection. When
chosen item is selected, press ENTER to confirm activation of chosen mode.
PRODUCTION
: Relay is only activated when inverter is connected to the grid
(contact closing across terminals “N.O.” and “C”)
FAULT
: triggers relay activation (contact closing across terminals “N.O.” and
“C”), only when an error signal occurs, i.e. when grid is disconnected, excluding
Input Under Voltage.
Fig. 22: alarm contacts terminal block
5.5.6.11 Remote Control
This function is used to disable inverter manual switch-off. Operation is as
follows:
- set to ENABLE to activate manual ON/OFF function
- set to DISABLE to disable manual ON/OFF function, so that Aurora operation
will only depend on external solar radiation.
Manual ON and OFF input is read on inverter digital input. When set to OFF, the
display will cycle through the following screens:
Production
Fault
Remote ON/OFF
Disable
Remote ON/OFF
Enable
Summary of Contents for AURORA PVI-6000-OUTD-AU Series
Page 16: ...Page 16 of 89 PVI 6000 OUTD xx AU Rev 1 0 Fig 3C Integrated switch and diodes models...
Page 39: ...Page 39 of 89 PVI 6000 OUTD xx AU Rev 1 0 Fig 18 Data Transmission Options...
Page 70: ...Page 70 of 89 PVI 6000 OUTD xx AU Rev 1 0...
Page 88: ...Page 88 of 89 PVI 6000 OUTD xx AU Rev 1 0 CERTIFICATE OF CONFORMITY...
