background image

2

Power-Flo Pumps & Systems • 877-24PUMPS • www.powerflopumps.com

General Safety Information

® Power-Flo  is a registered trademark of Power-Flo 

Technologies Inc. Alteration Rights Reserved. 1/16, 10/2020, 1/2021

Before installation, read the following 

instructions carefully. Failure to follow 

instruction and Safety information could cause 

serious bodily injury, death and/or property 

damage. Each Power-Flo pump is individually 

factory tested to insure proper performance. 

Closely following these instructions will 

eliminate potential operating problems, 

assuring years of trouble-free service.

 

 

 Installation, wiring,

 

 

 and junction 

connections must be in accordance with 

the National Electric Code and all applicable 

state and local codes. Requirements may vary 

depending on usage and location.

 

 

  Installation and

 

 

   servicing is to be 

conducted by qualified personnel only.

 

 

  This pump is 

not

 

 

   intended for use in 

 swimming pools, spa areas or water 

 installations where human contact 

 with pumped fluid. 

 

 

 Risk of electric shock. 

 

 

  To reduce risk of 

  electric shock, always disconnect 

  pump from power source before 

  handling. 

Lock out power & tag.

  In the event the 

  retaining screws have

  been pulled out of the

 housing, 

DO NOT

 replace them. Use

 of any other screw may short out 

 the stator windings, creating a risk of 

electrical shock.

  The addition of 

  petroleum based fluids 

or certain chemical additives to the system 

voids the warranty.

 Pumps build up heat 

 and pressure during

 operation. Allow time

 for pumps to cool 

 before handling or

 servicing. 

Features:

These Power-Flo Circulator Pumps are 

designed  to be installed in residential potable 

domestic hot water systems to provide 

recirculation (in a RETRO-FIT application where 

NO dedicated recirculation pipe has been 

installed) of domestic hot water resulting in 

“instant” hot water at fixtures throughout the 

house. This unit is designed to install 

ON TOP 

OF THE WATER HEATER

 on hot water supply 

side and will connect directly onto the supply 

nipple on top of the heater. This pump will 

come equipped with a standard terminal box 

to allow for connection to direct 115 V AC 

AND will come with a 6 Ft. long soft jacketed 3 

prong electric cord and strain relief connection 

for “outlet plug in” installations. 

NOTE: This 

unit MUST be installed with the Power-Flo 

Pumps “Retro-Fit Valve” (PFRFV)

 MOTOR: 

2-pole, 3600rpm, single phase,  

 

PSC with Thermal protection

 LIQUID TEMPERATURE: 

32°F - 230°F

 MAX. SYSTEM PRESSURE: 

145 PSI

 INSULATION: 

Class H

 VOLUTE: 

 Stainless Steel

 CONNECTION: 

 3/4” M x 3/4” FNPT

 POWER CORD: 

6 Foot with 3 prong plug

 ACCESSORIES: 

PFFP- Fitting Pack,  

PFDT - Digital Timer,  PFSOA - Snap-On 

Aquastat,  PFRFV - Retro-Fit Valve

 WARRANTY: 

3 year

Receiving Inspection

Upon receiving the pump, it should be 

inspected for damage or shortages.   If 

damage has occurred, file a claim 

immediately with the company that delivered 

the pump. Care should be taken to ensure 

the pump is 

NOT

 dropped or mishandled, 

dropping will damage the pump. If the 

manual is removed from the packaging, do 

not lose or misplace.

PFWRC67S1U 

 

Wet Rotor Circulator Pumps

WARNING: 

CANCER AND REPRODUCTIVE HARM-

WWW.P65WARNINGS.CA.GOV

Summary of Contents for PFWRC67S1U









Reviews: