2
Power-Flo Pumps & Systems • 877-24PUMPS • www.powerflopumps.com
Before installation, read the following
instructions carefully. Failure to follow
instruction and Safety information
could cause serious bodily injury,
death and/or property damage. Each
Power-Flo pump is individually factory
tested to insure proper performance.
Closely following these instructions will
eliminate potential operating problems,
assuring years of trouble-free service.
• Risk of electric shock. To reduce risk of
electric shock, always disconnect pump
from power source before handling.
Lock out power & tag.
• Installation must be in accordance
with the National Electric Code and all
applicable state and local codes.
• Installation and servicing is to be
conducted by qualified personnel.
• These pumps are NOT to be installed
in locations classified as hazardous in
accordance with the National Electric
Code, ANSI/NFPA 70.
• Keep clear of suction and discharge
openings. Do not insert fingers in
pump with power connected.
• Always wear eye protection when
working on pumps.
•
DO NOT
use power cord to lift pump.
Protect cable from cuts and punctures.
Do not handle power cable with wet
hands.
•
IMPORTANT!
This is
NOT
a submersible
pump. Keep pump and power cords
away from liquid.
• Do not us these pumps in water over
77˚F or run continuously for more than
1½ hours.
• Pumps build up heat and pressure
during operation-allow time for pumps
to cool before handling or servicing.
This pump is
NOT
intended for
use in swimming pools or any
body of water with human
contact. Pumps when used as a
decorative water fountain
pump
MUST
be used in circuit
protected by a Ground Fault
Interrupter. Installations in
Decoritive Fountains or Water
Features provided for visual
enjoyment MUST be installed
per ALL State and Local codes.
ALL
RETURNED
PRODUCTS MUST BE
CLEANED,
SANITIZED, OR
RECONTAMINATED
PRIOR TO SHIPMENT, TO INSURE
EMPLOYEES WILL NOT BE EXPOSED
TO HEALTH HAZARDS IN HANDLING
SAID MATERIAL. ALL APPLICABLE
LAWS AND REGULATIONS SHALL
APPLY.
General Safety Information
® Power-Flo is a registered trademark of Power-Flo Technologies Inc.
Other brand and product names are trademarks or registered trademarks of their respective holders.
Alteration Rights Reserved. 5/08, 6/09, 9/2020, 1/2021
PFUEG
Utility Pumps
IMPORTANT!
Prior to installation, record Model
Number, MFG Date,
and/or serial number, from pump
name plate for future reference.
Model:
Serial:
MFG Date:
WARNING:
CANCER AND REPRODUCTIVE HARM-
WWW.P65WARNINGS.CA.GOV
