Power-Flo Pumps & Systems • 877-24PUMPS • www.powerflopumps.com
7
Shaft Seal
Remove rotating member, spring and
retaining ring of seal (8) from shaft
(23). To remove stationary, remove cap
screws (43) and lockwashers (42) and pull
seal plate (6) from pedestal (25). Press
stationary out of seal plate. If any part
shows wear or damage replace complete
seal (8). Replace shaft sleeve (28) if worn
or damaged.
Handle all seal parts with care.
Do Not damage lapped faces.
Replace seal plate (6) onto pedestal (25).
Lightly oil shaft (23) and inner surface of
stationary. Press over shaft and into seal
plate (6).
Oil inner surface of rotating member and
with lapped surface facing pedestal, slide
rotating member onto shaft until lapped
faces of stationary and rotating member
are together.
Replace the rest of the seal. Replace shims
(10), (29) and impeller (11), making sure
that spring is properly seated against
impeller.
Pedestal & Shaft
Remove capscrews (34), lockwashers
(33) and bearing cap (36) from pedestal
(25). Remove shaft, slinger and bearing
assembly. To replace bearing (37) remove
retaining ring (35) and slinger (2). Press off
bearings (37) and (38) from shaft (23).
REASSEMBLE REMAINDER OF PUMP IN
OPPOSITE ORDER.
Receiving, Installation & Service
PF10ICU
Self-Priming Universal Pumps
