Power Fist 8091001, User Manual

Page: 5 / 24

6 pc Air Hammer Kit
Visit www.princessauto.com for more information 5
8091001 V 3.03
7. Use the tool with the least amount of vibration, when there is a choice between
different processes.
8. Do not use for extended periods. Take frequent breaks when using this tool.
9. Let the tool do the work. Grip the tool as lightly as possible (while still keeping safe
control of it).
10. To reduce vibrations, maintain the tool as explained in this manual. If abnormal vibrations
occur, stop using this tool immediately.
USE AND CARE OF TOOL
1. Use the correct tool for the job. This tool was designed for a specific function. Do not modify
or alter this tool or use it for an unintended purpose.
2. Do not carry the tool with fingers near or on the trigger/switch.
3. Avoid unintentional starts. Be sure that the regulator/throttle switch is in the neutral or OFF
position when not in use and before connecting it to any air source.
PARTS IDENTIFICATION
WARNING! Do not operate the tool if any part is missing. Replace the missing part before
operating. Failure to do so could result in a malfunction and personal injury.
Remove the parts and accessories from the packaging and inspect for damage. Make sure that all items
in the parts list are included.
Contents:
• Air Hammer
• 4 heavy duty chrome molybdenum chisels
• Tapered Cutter
• Angle Weld Breaker
• Spot Weld Breaker
• Panel Cutter
• 1/4 in. NPT male quick coupler
ASSEMBLY
INSTALL AIR CONNECTOR
Prepare a standard 1/4 in. NPT male air connector for use with your tool.
1. Wrap the external threads of the male connector with sealant tape.
a. Wrap tape in a clockwise direction so it will not unravel.
b. Do not tape all the threads. Leave several leading threads unwrapped for
easier alignment.
2. Screw the connector into the tool’s air inlet and tighten with a wrench until snug.
3. Run compressor at a low volume and check the connection for air leaks. Do not use the tool
until all air leaks are repaired or the faulty component is replaced.