Power Electronics SD750K, Hardware And Installation Manual

Page: 34 / 100

SD750K POWER ELECTRONICS
32
RECEPTION, HANDLING AND TRANSPORTATION
EN
RECEPTION, HANDLING AND
TRANSPORTATION
CAUTION
Read carefully the following installation instructions for a correct mechanical installation.
Otherwise, the equipment can be damaged and lead to personal injury.
Reception
Power Electronics’ equipment are carefully tested and packed for shipment. In the event of damage to
the unit during transportation notify the transport agency and Power Electronics: 902 40 20 70
(Interna34 96 136 65 57) or your nearest agent, within 24h from receipt of the goods.
Make sure model and serial number of the drive match the information on the delivery packing list.
The drive should be stored in a location that is protected from direct sun and moisture excess. The
storage temperature rating for the drive is -40°C and +70°C, < 95 RH without condensation. It is
recommended not to stack more than two units.
Standard storage
In case the equipment is stored for a short period (up to 6 months) before its connection, the following
rules will keep the unit safe until it is ready for installation:
•
The equipment should be stored in a location that is protected from moisture (inside and outside
the equipment).
•
Avoid floodable grounds. No part of the equipment should ever be submerged under water.
•
Temperature in the storage location must be kept between -40ºC and +70ºC (-40ºF and
+158ºF).
•
Store unit on a flat, even surface.
•
Store unit away from high traffic areas where the drive could get damaged.
•
Make sure animals cannot get inside the unit.
•
Keep doors closed and covers in place during storage.
•
Store unit away from corrosive chemical products or gases.
•
Keep the equipment packed until the moment of installation.
5