SD700SP
POWER ELECTRONICS
20
MECHANICAL INSTALLATION
MECHANICAL INSTALLATION
CAUTION
The installation must be done by qualified personal.
Otherwise, the equipment can get damaged and lead to injury to people.
NOTICE
Environmental ratings
It is recommended to follow the instructions of this manual to ensure the correct operation of the drive.
The installer has the responsibility of a properly indoor installation to ensure the ambient conditions of
the VFD. Additionally, the installer is ultimate responsible of the local regulation fulfilment. The
environmental ratings are the following ones:
▪
Environmental category:
Indoor
▪
Wet locations:
No
▪
Pollution degree:
PD3
▪
Ingress protection rating:
Clean zone: Electronics IP54 or IP20
Power connection and Input filters: IP20
▪
Operation Ambient temperature:
-20ºC to 50ºC Heavy duty
▪
Storage Ambient temperature:
-40ºC to 70ºC
▪
Humidity:
10 % to 95 % (non-condensing)
▪
Maximum altitude and power derating:
1000m 1% PN(kW) per 100m; 4000m maximum
▪
Vibration (IEC60068-2-6):
Amplitude ± 1mm (2Hz
– 13.2Hz), ±0.075 (13.2Hz –
57Hz)
Acceleration 6.86m/s² (13.2Hz-57Hz), 9.8m/s
2
(57Hz-
150Hz)
▪
Audible Noise:
< 79dB
▪
Painting:
Standard colour RAL 7047 in the front part and
RAL 7016 in the rear part, other under request
The mechanical installation described in this manual is for the SD700SP without solar kit.
7
Summary of Contents for SD700SP Series
