power automation PA 8000 LW Series, Installation Instructions Manual, Page: 91 / 132

5 Installation
Danger of injury due to improper installation and commissioning!
Improper installation and commissioning can result in severe per-
sonal injury or material damage.
n Prior to beginning installation, ensure that there is sufficient space
to work.
n Handle open sharp-edged components with care.
n Make sure that the assembly location is clean and well organized.
Components that are loosely stacked or lying around can cause
accidents.
n Assemble components properly.
n Secure components so that they cannot fall or tip over.
5.1 Prerequisites and preparations
5.1.1 General requirements
– Ensure that the control unit's operating condition requirements are
met.
For further information see
Ä
Chapter 4.3 “Operating conditions” on page 84.
– Ensure that the operating conditions requirements of the machine
to be connected to the control unit are met.
For further information see the CNC machine's manuals.
Prerequisites for installation are influenced by the control unit's
required operating conditions and must also take into account the
machine to be controlled.
Electronic components (e.g. mainboards, power supplies, hard disks)
have to be adjusted to the ambient air temperature before using. The
components must not put to power until their temperature is the same
as the ambient temperature.
Safety
L
WARNING
PA 8000 LW CNC control unit
Installation
25.09.2015 | 91