power automation PA 8000 LW Series, Installation Instructions Manual, Page: 73 / 132

The control unit is equipped with a PS2 connector that can be used for
a standard keyboard connection.
Fig. 45: Keyboard connector (PS2 mini)
Keyboard installation
This connector must be used when no operator's panel is installed.
This connector can be used to connect an additional secondary key-
board.
Connection of PA operator's panel
– Ensure, that the panel's keyboard is connected to the CNC opera-
tor's keyboard connector (Fig. 36 pos. 4).
– Ensure, that the built-in PA keyboard cable (Fig. 36 pos. 2) is con-
nected to this PS2 connector (Fig. 36 pos. 18).
When connecting a PA operator's panel with keyboard, the following
requirements have to be met:
Supported panels
n CP 121
n CP 121 T
Property Value
Pins 6
Connector type PS2 mini DIN
Gender female
Pin
(Fig. 36)
Assignment
1 data
2
3 GND
4 power 5V
(X3) PS2 Connector For Keyboard
(4)
PA 8000 LW CNC control unit
Design and function
25.09.2015 | 73