power automation PA 8000 LW Series, Installation Instructions Manual, Page: 101 / 132

n If in doubt, contact the Power Automation's customer support.
For contact information see
Ä
Chapter 9 “Service and return
process” on page 119 .
5.4.1 Wiring example for 2416EL modules
Fig. 62: Cabling example for 2416EL modules
1 Power supply
2 Fuse (slow)
3 Input signals
4 Inputs
5 Module 2416EL
6 Outputs
7 Output signals
8 Resistive load
9 Inductive load
Personnel: n Skilled electrician
1.
Set up inputs according to the schematic.
2.
Set up outputs according to the schematic.
3.
Set up power supply for outputs.
Ensure that the circuit is protected by a fuse of appropriate rat-
ings.
Inductive loads
Digital outputs switch very quickly. This fact must be accounted for
when inductive loads, like for example relays, are connected.
n When connecting inductive loads to outputs, ensure that a
recovery diode is connected in parallel as shown in the schematic
(pos. 9).
Schematic
PA 8000 LW CNC control unit
Installation
25.09.2015 | 101