Powell BriteSpot BSG3, Instruction Bulletin

Page: 47 / 57

Powered by Safety
®
37 Usage
01.4IB.48040C
c. The initial log that will be displayed
shows the log information that occurred
at the most recent alarm event.
d. Use the “Back 50”, “Back”, “Next” and
“Next 100” buttons to navigate through
the log.
e. If the Log Time says “No information”
then the log is finished or no logging
has taken place.
f. The ERASE LOG button will erase the
log, only use this if necessary.
g. Confirm the erase by pressing “Yes,
erase the log” button
Figure 47 Confirming Log Erase
Are you sure you want to erase ALL log information?
g. f
ActOry
r
eSet
Under some circumstances it may be desirable
to return the G3 Conversion Module back to
the factory configuration. In situations where
the administrator password or IP address
are lost or compromised, perform the reset
procedure as outlined.
1. Remove power from the conversion
module.
2. Using a piece of the polymer fiber, insert it
into the hole labeled “RST” and depress the
concealed button while applying power
to the device. Keep the button depressed
until both the “SYS” and “COM” LEDs stay
green (about 5 seconds). The hole for the
“RST” button has been designed to allow an
end from one of the probes to be inserted.
3. Release the button and the device will
restart with its default values.
Figure 48 Inserting Fiber into RST Button
10/100
STAT
RST
ID#: Brit
eSpot G3
BS3
BS2
BS1
4
7 8 9
1
LINK
COM
SYS
10/100
STAT
RST
LINK
COM
SYS