- 56 -
0600_GB-Power-Control_8537
GB
POWEr COnTrOL - OPErATiOn
Seed Menu
• Press
“Seed menu” key
- Information about seed type and amount of seed
is shown on the display
2.1
Seed type
(= Saat)
- Indicates the selected seed type
see section „Setting seed amount“.
2.2
Gearing position
(= Getriebestellung)
- indicates the calculated gearing position through
the control
2.
Actual quantity
(= Istmenge)
- The actual quantity selected by the user is shown
here
- The actual quantity changes if the keys
or
are pressed.
(Seed quantity change in %)
2.4
Set quantity
(= Sollmenge)
- Indication of the set quantity (= seed quantity)
according to seed reference
see section „Seed reference“.
2.5
Increase output
Press
key
- Seed quantity is increased (in a definite example
around 10%)
- If the machine should stop with this, the prompt
“Turn crank handle” appears because the drive
may not be adjusted upward when at a standstill.
- If the key is operated during travel or the crank
handle is turned on the drive shaft front end, the
hectare meter registers the turning of the drive
shaft, the prompt “Turn crank handle” fades and
the instruction is carried out.
- The electro-cylinder starts the new drive setting.
Note!
The seed menu can
be exited in the
following ways:
Use keys
,
,
,
,
or
2.6
Reduce output
Press
key
- Seed quantity is reduced (in a definite example
around 10%)
- If the F2 (equals -10%) key is pressed twice the
seed quantity is reduced by 20%
- The electro-cylinder starts the new drive setting.
2.7
Set output back to set value
(according to seed table)
Press
key
- Set any previously altered actual value to set value
again.
- For the time being set value and actual value are
the same.
- If the reduced seed quantity (actual quantity) should
be the same as the set quantity again, this can be
achieved by pressing the (100%) key once.
- If the machine should stop with this, the prompt
“Turn crank handle” appears because the drive
may not be adjusted upward when at a standstill.
- If the key is operated during travel or the crank
handle is turned on the drive shaft front end, the
hectare meter registers the turning of the drive
shaft, the prompt “Turn crank handle” fades and
the instruction is carried out.
Tip! If the actual quantity differs to the set
quantity, the indicator field will be 100%
black.
2.1
2.5
2.6
2.2
2.7
2.4
2.
