- 2 -
GB
0700-GB FAHRGASSE_8521
TrAMLinES
At the edge of the field (row marker lowered on field-side) set the
tramlining cycle to the correct starting number – e.g. for rhythms
and 4 set to
2
.
Sensors handle the automatic switching, e.g. when changing row
markers.
For
symmetrical
tramlining cycles with even numbers, begin at the
edge of the field with _ drill working width; switch off the left machine
half by disconnecting the plug in the middle of the sowing shaft.
If the fertiliser spreader is equipped with a spread limiter, begin at the
edge of the field with full drill working width
and Tramline
.
Two or three sowing rollers may be switched off per wheel track
(magnetic switch/sowing roller – connection sleeves
73/1
+
2
).
The magnetic switch switches „off“ when it receives power; this
ensures that operation may continue for the full number of rows
in the case of a power failure. (Shutters may then be closed if
necessary.)
For
asymmetrical
tramlining, switching occurs only on one single-
sided wheel track during each of two passes in opposite directions.
Depending on the turn direction chosen, the unneeded magnet on
the outer side of the turn must be deactivated by uncoupling.
ATTENTION:
When changing over from asymmetric to asymmetric marking,
the distances that were marked are not the same
e.g. Track = 1.80 m
symmetric = 90 cm
(Centre track width = centre drill machine)
asymmetric = 90 cm
(Centre track width = outside drill machine)
(Note: The unit is supplied with both magnet couplings
connected. For this reason the magnets must be
checked after selecting the tramlining rhythm and
drive direction!)
7
75
76
(In connection with „Multitronic“ and loading platform only.)
The tramline may be marked using track discs for pre-emergence
spraying.
Switching is handled automatically. The electromagnetic valve is
located on the front end of the machine.
Adjust the disc markers to tramline track-width (
75/1
).
To make an asymmetrical tramline in off-set tracks, fold up and secure
the unneeded tramline marker.
For transport, the disc booms must be folded up and locked – plug
(
76/1
).
Examples of Tramlines
If no tramlines are to be made but the electronic monitor is to remain
active, select rhythm „
0
“.
(Adjusting the tramlining rhythm: see
appendix A
,
section 5.1.1
)
Current operation data is stored so that operation may continue in
the correct rhythm after e.g. an interruption.
If the seed drill has been out of operation for a longer period, the
tramlining control must be inspected. Check that the sowing roller
connection sleeves (
73/2
) are not restricted by seed dressing residue
and move easily on the sowing shaft.
when driving on public roads, disconnect all
electronic equipment from the on-board power supply
(disconnect plug on tractor side).
Demarcation of Tramlines
