- 40 -
1902-GB Maintenance_2740
EN
mainTenance
general safety information
DANgER
life-threatening danger exists if another person starts
up the tractor and drives away or actuates the control
lever of the hydraulic system while you are engaged
in maintenance.
•
Before carrying out maintenance and repair
work, switch off the engine. remove the key
and engage the steering lock. .
DANgER
life-threatening danger exists, if the machine starts
to move or tilts.
•
Before any maintenance and repair work,
park the machine on even, firm ground.
•
Secure the machine against rolling using
wheel chocks.
•
Do not work under the machine unless it is
safely supported.
Transmission
Oil quantity:
1.3l litre SAE 90
Oil level check:
The oil level is correct if the gear oil
reaches the middle of the inspection window (1).
1
Oil change:
After the first 50 hrs
then every 500 hrs
The oil can be changed only when the swath curtain is
in lowest position. (see section Swath curtain height)
Otherwise the oil plug (2) on the lower side of the gear is
not accessible.
2
1
Position of the filling screw (3):
right in driving direction on the gear (see figure)
3
Chassis
Steered chassis
Setting the steering axle:
Only if the frame chassis does not trail aligned behind the
tractor when travelling straight ahead!
1. Loosen locknut at position (4)
2. Remove splint (5) and loosen nut at position (5)
at the start of the steering rod, directly behind the
tractor.
3. Pull steering rod up and away.
4. Turn the spindle (6) until the required steering axle
position is reached.
5. Re-fit ball joint
6. Re-insert splint at position (5) and re-tighten nut at
positions (4, 5).
4
6
5
