EN
operaTion
2200_EN-Einsatz_2740
- 24 -
Example: left rotor with tandem chassis:
Requirements:
- level and firm ground
- 1.5 bar pressure in all tyres
- The machine is attached to the tractor and in the working position
1. Step:
Lower the tines using the crank handle. The lowest tines
should no longer sweep the ground when the rotor is turned.
2. Step:
Adjust the transverse inclination to the "start raking" position
using the eccentric screws, so that a ground clearance of
approx. 1 - 1.5 cm can be measured on the first triggered
tines (start raking).
TIP
Set both eccentric screws equally on the same side of
a rotor unit.
3. Step:
Setting the rake height using crank handle. The ground
clearance in the "rake start" position should now be approx.
3.5 cm. The ground distance at "finish raking" position
should now be approx. 2.0 cm.
4. Step:
NOTE
Property damage through operation without an inner
feeler wheel
•
Always operate the machine with an inner
feeler wheel. The carrier and holder of the
external feeler wheel are not designed for
stand-alone operation.
Set the inner feeler wheel so that the tines in front of it
have a ground clearance of 2.5 cm.
5. Step:
Setting the outer feeler wheel (multi feeler wheel)
so that it is only slightly loaded.
639-13-12
3,5 cm
2,0 cm
2,
5
cm
Start raking
F i n i s h
raking
3. Step
3. Step
5. Step
4. Step
