EN
operaTion
2200_EN-Einsatz_2740
- 22 -
TIP
There is only one crank handle on the machine. Take the
crank handle with you to the second rotor unit.
Secure the crank handle with the spring pin after fitting it.
The crank handle (3) park position on the main frame.
3
Setting the raking height:
1. Set the required rotor unit on the terminal (right, left,
both).
A
B
C1
C2
• To do this, push the shift lever of the required rotor
units (C1, C2) upwards (= raking height).
2. Set the required raking height using the dual-acting
control unit.
3. On the terminal, put both levers (C1, C2) down again
(= working width). Then the raking height cannot be
further adjusted.
Terminal position on the parked machine:
Using a T-screw, the terminal can be attached to the parked
machine on the shaft (4) underneath the cable tray.
4
Terminal position in the tractor cabin:
Position the terminal in the cabin using the suction cup so
that it is visible and easily reached.
Comfort control for raking height and single
rotor operation:
A
B
C1
C2
The machine can be switched from the working position
or headland position to the transport position using key A.
Using this key makes it possible to skip the lock between
headland and transport position.
Set the rotor to be operated by control unit 1 using switch
B. Single-rotor operation
Left - left rotor
Centre - both rotors
Right - right rotor
With switch C1 (= left rotor unit) and switch C2 (= right
rotor unit), it is possible to change between hydraulic height
adjustment (= up) and working width (= down).
TIP
Always place this lever at swath width after setting the
raking height. Doing this will prevent the raking height
from being unintentionally altered.
The smooth hydraulic raking height operation:
The screws (5) are centrally fitted on the rotor unit inside
the motor.
Should the raking height reset itself during operation,
readjust the screws (5).
- To increase the smooth operation of the hydraulic
raking height adjustment, loosen the screws (5).
- To restrict the smooth operation of the hydraulic
raking height adjustment, tighten the screws (5).
5
