(955) 9700-GB WARTUNG
GB
MAINTENANCE AND SERVICE
- 19 -
Basic setting of the ploughing component
Checks must be made in the following order after replacing worn out parts:
1. Stand the plough on even ground.
2. The gap (A) between plough and blade cutting edege must be the same for all ploughing components.
3. Check the gap (B1) on the last ploughing component.
B1 = 0 - 5 mm for ploughing components* of the type W, UWS
10 - 20 mm for ploughing components* of the type UW, UWS, WSS
4. Set the same measurement for gap (B) as for B1.
* The type of ploughing component is shown clearly on the manufacturer’s plate.
Setting the ploughing component tilt
If the plough is not penetrating the ground correctly, an improvement
can be obtained by turning the eccentric bush.
• The blade point in the area „S“ is set either higher or lower depending
upon the position of the eccentric bush (A or B).
• Retighten screws after resetting.
On some models a catch plate is fitted instead of an eccentric bush.
See
"Basic setting of the ploughing component"
also.
