- 10 -
1100-GB_Anbau_2441
GB
ATTACHING THE MACHINE
Safety
advice:
see Supplement
A1, points1-8.
Machine attachment
Hitching the machine to the lifting gear of the tractor.
- Link full floating axle to lower link
- secure coupling bolts (1) properly
- Secure with linch pin (3)
Connecting the cardan shaft
- Turn motor off and remove ignition key
- Clean and grease machine’s attachment profile and tractor’s p.t.o. shaft before attaching cardan shaft.
- Attach wide angle joint (4) to machine first. Then attach cardan shaft to tractor’s p.t.o. shaft
- To prevent protector cap on all shafts from turning, secure it with chain (5)
- Before operation, check lengths of drive shafts and
adapt if necessary (see chapter "Adaption of Drive
Shaft" in supplement B also).
Procedure for cutting to length
- Zur Längenanpassung Gelenkwellenhälften in kürzester
Betriebsstellung (L2) nebeneinander halten und
anzeichnen.
3
1
4
5
• Bring running frame into horizontal position
025-05-04
L2
Attention!
Attach and ope-
rate the swather
running frame
in a horizontal
position using the
tractor’s lifting
gear. Otherwise
the danger of
deforming the
spring tines exists
when lifting and
lowering the
rotor!
