- 50 -
1800_ EN-Gelenkwelle_BA-ALLG-150h
EN
PTO shafT guarding
Supplement - B
Safety chain
- Use chain to prevent tube guard from rotating.
- Ensure sufficient swivel space for the cardan shaft!
- Trim the safety chain so that it cannot wind around the
cardan shaft.
Instructions for working
Do not exceed the permissible pto speed when using the
machine.
- The attached machine may run-on after the pto is
switched off. Work must only be performed on it once
it has completely stopped.
- When parking the machine, the cardan shaft must be
taken off or secured using a chain, as instructed. Do
not use safety chain (H) to suspend the cardan shaft.
Wide-angle joint:
Maximum angle for operation and at standstill 70
°
.
Normal link:
Maximum angle opening in standstill 90
°
.
Maximum angle opening in operation 35
°
.
Maintenance
Adapting cardan shaft
NOTE
Material damage - due to inferior spare parts
•
Only use the cardan shaft supplied or stat-
ed; otherwise the warranty claims for any
damage are not valid.
The correct length is determined by comparing both cardan
shaft halves.
Cutting to length procedure
-
To adapt the length, hold cardan shaft halves side by
side in the shortest operating position (L2) and mark.
Caution!
• Note the maximum operating length (L1)
- Aim at the maximum possible tube superimposition
(min.
1
/
2
X)
• Shorten the inner and outer safety tube equally
• Attach overload protection (2) to the machine!
• Always check that cardan shaft locks are securely
engaged before starting work.
