- 9 -
0700_GB-Wireless-Power-control_5543
Wireless PoWer conTrol - conTrol
GB
AC discharge
Energy saving mode with AC operation
- If the terminal is not being used when switched on (no
key activation), after 15 secs the display backlighting
blacks out. If a key is pressed while in this state then
the backlighting is fully activated immediately.
- If the AC has reached a particular discharge level
(LED is red or quick blinking red), then a charging
recommendation (battery symbol) appears on the
display. An acoustic signal is also heard.
- To prevent a complete discharge if AC capacity is low,
the terminal switches off automatically. (The LED blinks
red quickly just before switching off.)
- The terminal running time (time not in energy saving
mode) depends on the operator. With heavy usage of
a fully charged AC, the device can be used for approx.
4 hours without recharging. (This value is applicable to
as-new ACs.)
Pairing
- Pairing serves as a secure point to point connection.
Information can be transferred only between paired
partners.
- A wireless kit contains an operating device and a cradle
among other things. A receiver is integrated into both
the terminal and the cradle. Both partners are already
paired when delivered. If partners are to be newly
paired then proceed as follows:
To delete the partner address stored in the cradle,
the accompanying magnet must be passed over
the marking (light brown adhesive label) with cradle
switched on.
After that switch cradle to standby. When cradle is
switched on again, within 0 secs. the terminal must
be switched on by pressing STOP key.
Keep pressing STOP key until hourglass appears on
the display.
- When the “WORK” mask appears on the display then
pairing was successful.
(Prerequisite: the job calculator is connected and ready
for operation)
- The connection set-up process can take up to 0 secs.
If the terminal is connected to a PC to enable operating
details to be read, pairing takes place automatically
through the PC. A new manual pairing is not necessary
after connecting to a PC.
Radio contact range
- With information transfer between device and job
calculator then radio contact is as per bluetooth
standard V1.1.
- Hardware is subject to bluetooth class 2 with a
radio range of approx. 10 m, depending on local
conditions.
