- 29 -
0701_GB-Power-control_5543
GB
PoWer conTrol - oPeraTion
Power control initial operation
Switching on control panel by
- briefly pressing
I/O button
The control panel starts in the work indicator
By
briefly pressing
the I/O button
the DATA
indicator appears
Display for
- Job calculator soft-
ware version (V x.xx)
- Loads (L)
- Operating hours (h)
The DATA indicator appears after 4 secs returns to the
WORK indicator.
By pressing the I/O button once again
in the DATA
indicator appears the SET
indicator.
Switching through to
the SET functions by
further pressing the I/O
button is possible
Switch back from SET
indicator to WOrK indicator by
-
pressing the I/O button
for 1.5 secs
Switch off the control panel and job calculator by
-
pressing the I/O button
for secs
Cancel the DIAG
indicator (Alarm signal)
by
- pressing the I/O button
WORk Menu loading functions
1. Automatic loader
Press button
- automatic loader is switched On or OFF
- active automatic loader is shown on display
Switching automatic loader on and off is possible only
when tailgate is closed!
Advantages of the automatic loader
- very compacted load
- minimum blockages in the feeder channel
- prevents overloading the entire drive
- forage protection
- relieves the driver
- increase in load capacity
Control of the automatic loader through
- level flap underneath
- level flap on top
- scraper floor drive is switched on automatically
- forage is conveyed back a short distance
- procedure is repeated until the loading space is full
The wagon is full when the forage
- presses against the lower regulating roller, or
- presses against the tailgate (wagons without
regulating rollers)
When the wagon is full
- full indicator (Full) appears on the display
- the counter for the number of loads increases by
one
Take note!
The automatic loader needs to be switched
on only once.
When the wagon is full
- the automatic loader is automatically deactivated
After unloading
- the automatic loader is activated again automatically
Setting is maintained even after switching the system
on and off
Note!
The following
operating
manual applies
to trailers fitted
with all additional
equipment.
Note!
An automatic
loader is not
possible on
machines with a
collapsible top
frame.
Take note!
Load counting
takes place either
through the full
indicator (FULL)
or through the
status sequence
“Tailgate to
tailgate on
scraper floor
– reverse run 10
seconds”
