- 26 -
0601-GB-DIREct-contRoL_563
GB
DirecT conTrol - oPeraTion
Pivoting drawbar / Forage top frame
These functions can be carried out with the red as well
as the green LEDs
- The “pivoting drawbar” function is the standard
setting.
Raising pivoting drawbar /
Raise forage top frame
Press button and hold
(= touch function)
- wagon is raised at the front or
- forage top frame is raised (switch over)
Lower pivoting drawbar /
Lower forage top frame
Press button and hold
(= touch function)
- wagon is lowered at the front or
- forage top frame is lowered (switch over)
- If the “Forage top frame” function is required, switch
to another mode
Adjustment process:
- Switch operating device off
-
Press and hold
key, then
Briefly press button
(2 secs.)
- Both LEDs “Forage top frame raise” and “Forage
top frame” lower blink alternatively
Each time the operating device is switched
off the setting reverts to the pivoting drawbar
function.
Safety hints!
See the relevant
chapters in this
operating manual!
Unloading functions
Open tailgate
Press button
(= rest function)
- the tailgate is raised
- the dosing rollers are switched on (if provided)
- the integrated LED lights up
Close tailgate
Press button
(= rest function)
- the tailgate is lowered
- the scraper floor is stopped
- the dosing rollers are switched off (if provided)
- the integrated LED lights up
Note!
If the tailgate automatic is interrupted by
another function (e.g. pivoting drawbar), the
tailgate remains on hold until the other function
is finished.
Unload scraper floor and
increase scraper floor speed
Press button
(= rest function)
- the scraper floor runs backwards (when tailgate is
opened)
- the integrated LED lights up
- The speed can be increased through further
pressing
Note!
After 5 seconds the up-to-date value is stored
and used as the start value for the next unloading
procedure (only with automatic unloading)
- Briefly press button
- The mode is changed
- The LED in the I/O key
glows green
- Only the green symbol
functions are active
- Select the required
hydraulic function
- The (LED) in the selected
key glows green
Decrease scraper floor speed
Briefly press button
(= touch function)
- decrease scraper floor back run speed
- the integrated LED lights up
- the speed is reduced further each time the key is
pressed
Scraper floor forward run
Press button and hold
(= touch function)
- Scraper floor moves toward the Pick-up
- the integrated LED lights up
note!
Use this key to stop scraper floor back run
also