- 16 -
0700_GB-Schneidwerk_1612
GB
Cutting Unit
Important checks to be carried out on the
cutter beam before each operation
- left and right hand pins locked (E2)
- for wear on the cutters
- for dirt on the cutter overload fuse
- for adequate ground clearance (A)
Important!
Lock the cutting beam with bolts
• Position E2
- on the left and right side of the vehicle
- secure both bolts with forelock (V)
Attention!
Before any
operation check
that the pins left
and right are
locked!!
General information
To facilitate maintenance work on the cutting unit, the
cutter beam can be swung on to the left-hand side of
the vehicle.
All cutters are then accessible:
- for grinding the cutters
- for installing or removing the cutters
- for cleaning
External cutting unit buttons
For maintenance work on the cutting unit, the cutter beam
can be swung in or out using both buttons (57).
Use these buttons only when the loading channel is empty
and the press drive is turned off!
Attention!
Take care that the cutting unit is in proper working
order before swivelling it in (damaged cutters,
warped components, etc).
Advice in case of press channel blockage
Warning!
When a blockage in the press channel occurs,
DO NOT use the button (on the right) to swivel the cutter
bar out as this will occur under hydraulic pressure.
Remedy
- Press and hold the
button on the operating device,
and at the same time switch on the p.t.o.drive.
The feed pressure of the load while cardan shaft is
running will swing the cutter beam out.
- After removing the blockage swing the cutter beam in
again.
Attention!
Increased chances
of injury with all
work carried out
on cutter bar,
particularly with
swinging cutter
bar in from the
side or when
swivelling it up!
cuTTing uniT, cuTTer beaM
