- 1 -
0700_GB-Schneidwerk_1612
GB
cuTTing uniT, cuTTer beaM
Adjusting the cutters
• The setting should be such, that the cutters are centred
between the dovetail prongs of the press rotor.
Centring the cutters between the dovetail
prongs
1. Loosen locking nut (k)
- on the left and right-hand side of the vehicle
2. Unscrew the bolts (Sk-1, Sk-2) a little, on one
side of the vehicle.
If the cutter frame has to be moved to the left:
- first of all loosen the bolt (SK-1) on the left-hand
side of the vehicle
- then tighten the bolt (SK-2) on the right-hand side
of the vehicle. By loosening this bolt, the cutter
frame can be moved as far as necessary to centrally
position the cutters between the dovetail prongs of
the press rotor.
If the cutter frame has to be moved to the right:
- first loosen the bolt (SK-2) on the right–hand side
of the vehicle
- then tighten the bolt (SK-1) on the left-hand side of
the vehicle.
3. Tighten both bolts (Sk-1 and Sk-2) as far as they
will go.
- Do not tighten bolts excessively
4. Secure both bolts (Sk-1 and Sk-2) with locking nuts
(k).
Adjusting the cutter beam
• When the cutter frame is swung back in, the setting
should be such, that it enables the frame tubing to fit
into the opening on the moulded frame without any
difficulty (1)
Adjustment on the swivel axis of the cutter beam by
means of a screw (SK-4)
Setting
1. Loosen locking nut (k)
2. Turn screw (Sk-4) accordingly.
When the cutter
frame is swung
back in, the setting
should be such, that
it enables the frame
tubing to be pushed
over the slide.
- The frame tubing should slide on approximately mm
under the highest point (see sketch).
3. Secure screw (Sk-4) with locking nut (k)
Setting for cutter beam in swing-out position
Setting should be so that when cutter beam is swung
out, the pins (B) should be approx. in the centre of the
slot. (x = x)
• Set using bolt (SK-5) on underside of cutter beam
