- 20 -
1200_GB-SCHNITTHOEHE_344
STARTING WORK
GB
Operation
Set cutting height by turning upper link spindle (mower
drum incline, max. 50)
Central cutting height adjustment
The cutting height can be set anywhere from 35 to 65
mm by adjusting the centre disc.
1. Lift unit with loader (~5 cm).
2. The key (W) is put on the square or hexagon and turned
until the required cutting height is set.
Turn once = 1,5 mm
Cutting height adjustment
Safety points
- Turn engine off when
adjustment, service
and repair work is to
be done.
- Do not work under the
machine without safe
support.
- Retighten all screws after the first hours of operation.
Distance plates
• The cutting height is set by inserting distance plates
(4mm, 6mm).
2 of which have already been inserted (4mm, 6mm) in
the factory.
Optional equipment:
8 distance plates (6mm)
Optional equipment:
high-cut mowing plate (H1)
• Each mowing drum must have an equal number of
plates inserted.
Inserting distance plates
1. Remove both skide plates (S1, 1a).
2. Insert distance plates (6mm).
3. Refit both skid plates.
Replace worn or damaged spring lock washers with
new ones.
Similarly with worn screws and nuts.
Tighten all screws firmly!
4. Check after the first hour of operation
Check all screws for tightness.
TD 79/99/10
~ 5cm
TD 79/99/05
099-02-06
