1/2
Classic Medicine Cabinet – Regular and Extra Large
Note: Professional Installation Required
Important Safety Instructions:
z
Please read all instructions carefully before assembling. For your safety, assembly by two people is recommended.
z
This hanging system is meant for drywall/stud mounting only. If walls are concrete, brick or plaster, please consult your
local hardware store for assistance.
z
When mounting to a stud use only wood screws.
z
The maximum individual shelf weight capacity is 20lbs (9 kgs). Do not exceed the load capacity.
Parts Included: Tools required (not included):
(A) Cabinet (1pc) Phillips Head Screwdriver
(B) Glass Shelf (2 pc) Pencil
Stud Finder
Felt Tipped Pen
Hardware Included:
(C) L-Shape Peg (8 pc) (D) Wall Bracket (1 pc) (E) Level (1 pc) (F) Toggle (2 pc) (G) Toggle Screw (2 pc)
(H) Stud Screw (1 pc) (I) Anchor (1 pc) (J) Anchor Screw (1 pc) (K) Plastic Plug (2 pc) (L) Rubber Sheet (2 pc)
Pre-Assembly:
z
Remove all parts and hardware from the box and lay out on a clear workspace, along with any plastic protective packaging.
Do not dispose of any contents until assembly is complete to avoid accidentally discarding small parts or hardware.
z
Use the parts and hardware lists above to identify and separate each of the pieces included.
z
The illustrations provided allow for easier assembly when used in conjunction with the assembly instructions.
z
Keep all parts and plastic bags out of the reach of children.
INSTALLATION SUMMARY: FIND WALL STUDS, MOUNT WALL BRACKET TO THE WALL,
HANG PRODUCT ONTO THE MOUNTED WALL BRACKET
FIND WALL STUDS:
z
Determine the desired placement on the wall for the product. Within that range, locate a stud using a stud finder and
make a small mark on the wall with a pencil at that location.
z
It is best to mount the bracket to at least (1) stud. Using Figure 1, determine which hole on the wall bracket will be over
the stud, this hole will take a wood screw alone.
MOUNT WALL BRACKET TO THE WALL
1.
Insert the supplied bubble level (E) into the channel of the wall bracket (D). Position the wall bracket (D) on the wall and
adjust so that the bracket is level and a pre-drilled hole of the bracket aligns with a stud. Then, use a felt-tipped pen to
mark the wall through appropriate pre-drilled holes of the bracket to indicate the locations of the drywall toggles (F). Also
make sure to mark the bracket itself at each selected pre-drilled hole using the pen. (Please refer to Figure 1 to
determine the location of the hardware.) The locations of the drywall toggles will depend on how the stud aligns with the
bracket. The user should make sure that the stud and the toggles are evenly spaced along the length of the bracket and
that the ends of the bracket should be secured using either a stud-mounted screw or a drywall toggle.
2.
Remove the wall mount bracket and set aside.
3.
Using a manual screwdriver, drive a toggle (F) into the drywall at each mark. To install these toggles into the wall, simply
rotate them at the marked location as if they were a large screw, applying smooth even force. DO NOT HIT THEM WITH
A HAMMER AND DO NOT USE A POWER DRILL TO ROTATE THEM. These toggles are designed to bore themselves
into the wall. Continue rotating until the toggle head advances flush with the wall surface.
4.
Once the toggles (F) are installed into the wall at the marked locations, reposition the wall bracket so that the marked
holes of the bracket align with the toggles. Using the supplied toggle screw (G) secure the bracket to the installed toggles.
