Possl Globecar Summit, Instruction Manual

Page: 82 / 104

80
Motorcaravan - 09/21-0 - GLO-MJ22-00EN
Sanitary fittings
11
11.3 Starting up the water supply
Starting up the water
supply:

Switch on the control panel with main button.

Switch on the water pump at the control panel.
The indicator light indicates the operation.

When the water tap is opened in the "warm" position (red point at the water
tap), the boiler and the lines are filled with water from the fresh water tank.
Ensure that the vehicle interior temperature e5 °C so that the frost
monitor of the boiler is not triggered.

The filling process of the boiler takes a few minutes.

When the water flows without air bubbles the boiler is filled. The resultant
lack of water in the fresh water tank can be topped up.
11.4 Water system
The water system and the tapping points in the kitchen, bathroom, shower and
toilet must be checked for leaks regularly and in particular at the beginning of
the season.
The water pump is put into operation via microswitches when the various
water taps (kitchen and bath) are opened or when the toilet is flushed. The
pump is self-priming. For the operation of the water system the control panel
has to be switched on and the water supply has to be activated.
11.4.1 Winter package (special equipment)
With the winter package which is available as special equipment the vehicle is
suitable for winter use up to outdoor temperatures of a max. of -10 °C and at
the same time an indoor temperature of at least +18 °C to +20 °C.
The waste water tank is equipped with a heater mat that prevents freezing of
the waste water tank when it is switched on.
If there is a risk of frost, switch the switch of the tank heater at the control panel
to the position "On".
The heater mat is controlled by means of a thermostat and switches off again
at a temperature of +5 °C.

The water system is not a pressurized-water system.

In the case of low temperatures there is a risk that all the water-bearing
lines as well as the hot water boiler can freeze up.

Since the heater mat has a considerable power consumption, the external
power system (230 Volt) has to be connected.