Checks
Before carrying out any checks on the machine, the drive unit MUST be switched off!
Disconnect the machine from the mains.
▪ In addition, pull out the plug of the device.
▪ Disengage the universal joint shaft on the tractor.
– Before disengaging, turn the manual throttle to minimum.
▪ Remove the universal joint shaft from the tractor.
Protective guards
All the protective guards (covers, safety grilles, etc.) must be in place on the machine at all
times!
Screw fittings
Tighten all screws and nuts after the first hour of operation.
Tighten the screws and nuts after every 100 hours of operation.
▪ Replace missing screws and nuts.
Electrical cables
Before each start-up, the condition of the electrical cables must be checked.
▪ Damaged cables must be replaced immediately.
Work on electrical equipment must only be carried out by qualified electricians.
Hydraulic lines
After the first hour of operation, check that all hydraulic connections are secure and are not
leaking.
Check that all hydraulic connections are secure and are not leaking after every further
100 hours of operation.
▪ Damaged hydraulic lines must be replaced immediately.
Tool guide
The tool guide must always be well greased.
"Fixomatic"
Each time, before starting work, check whether the lower splitting knife section is lowered
at a noticeably reduced speed.
8
8.1
8.2
8.3
8.4
8.5
8.6
Checks
26
