System Installation
LYNX-6000 Series User
’s Manual
2-1
Chapter 2
System Installation
This chapter provides you with instructions to set up your system. Definitions and
locations of all the interfaces are described so that you can easily configure your system.
2.1 M.2 Key E 2230 Wifi Module Installation
Step 1.
Remove 2 screws at the bottom of
the front bracket.
Step 2.
Remove 4 screws from the rear
bracket. Remove the rear bracket.
Step 3.
Pull out the bottom heat sink.
Step 4.
Turn around the system, you can find
M.2 Key E 2230 socket and Wifi module can
be installed on it.
Step 5.
Finishing the installation, put the
bottom heat sink back to the initial position.
Lock the front/rear bracket by screws.
Note:
Make sure to fasten the screw back with
proper torque (5kgf-cm) by torque wrench
on LYNX-6000. Improper torque may cause
the damage of screw thread on the
aluminum chassis.
