System Installation
WEB-45H3 User
’s Manual
3-19
Chapter 3 BIOS Setup Information
WEBS-45H3 system adopts WADE-8212 mother board. WADE-8212 is equipped with the AMI BIOS
stored in Flash ROM. These BIOS has a built-in Setup program that allows users to modify the basic system
configuration easily. This type of information is stored in CMOS RAM so that it is retained during power-off
periods. When system is turned on, WADE-8212 communicates with peripheral devices and checks its
hardware resources against the configuration information stored in the CMOS memory. If any error is
detected, or the CMOS parameters need to be initially defined, the diagnostic program will prompt the user to
enter the SETUP program. Some errors are significant enough to abort the start-up.
The following section describes the BIOS setup program. The BIOS setup program can be used to view
and change the BIOS settings for the module. Only experienced users should change the default BIOS
settings.
3.1 Entering Setup
Power on the computer and the system will start POST (Power on Self-test) process. When the message
below appears on the screen, press <Delete> or <ESC> key will enter BIOS setup screen.
Press<Delete> or <ESC> to enter SETUP
If the message disappears before responding and still wish to enter Setup, please restart the system by turning
it OFF and On or pressing the RESET button. It can be also restarted by pressing <Ctrl>, <Alt>, and
<Delete> keys on keyboard simultaneously.
Press <F1> to Run General Help or Resume
The BIOS setup program provides a General Help screen. The menu can be easily called up from any menu
by pressing <F1>. The Help screen lists all the possible keys to use and the selections for the highlighted
item. Press <Esc> to exit the Help Screen.
