USER MANUAL – Portman Custom Lights P1 Retro Lamp
|
Operation modes
14/23
without even touching neither ladder or fixture’s buttons. P1 Mini fully supports the
RDM standards.
Manual operation
The fixture works in manual operation when it’s not receiving DMX signal whether
wired or wireless. You can adjust the brightness of all filaments at once from main
screen, or you can control each source individually from the “MANUAL CONTROL”
option in the menu (refer to the “Menu” chapter to learn how to manually control
channels). To enter menu simply hold enter for 2 seconds.
DMX 512 modes
The fixture automatically switches into DMX mode after receiving DMX data. To learn
how to change the DMX address or signal source (wired or wireless) refer to the “Menu”
chapter. When the fixture works in the wired DMX mode You can daisy chain fixtures
using 5 pin DMX wires. When daisy chaining remember, that you can connect up to
32 devices per DMX 512 universe. Always terminate the DMX 512 line. Put the 120
Ω
terminator into last device’s DMX OUT XLR socket.
When the fixture works in the wireless mode (only when WDMX card is installed) it is
receiving DMX 512 signal from Wireless Solution Sweden transmitters and can send
the signal throughout the 5 pin DMX OUT XLR socket. You can put the fixture with
WDMX card installed as a first fixture in a line and use it as a WDMX receiver. The P1
Mini supports bi - directional WDMX TRX module. It means, that the fixture supports
RDM in wireless mode too. To link P1 Mini with W-DMX transmitter first use “UPAIR
ALL WDMX DEVICES” option from menu, than turn the scanning mode on in the
transmitter. Transmitter will link with all unlinked devices. For more detailed
information please refer to your transmitter’s user manual.
