Porsche 996 TT, Repair Manual

Page: 738 / 2099

14. Install the starter ’ 276019 Removing and installing starter.
15. Install the front cross member.
16. Connect the battery and carry out the necessary subsequent work ’ 0 Entire Vehicle − General, 0
Power supply (work instructions after connecting the battery).
CAUTION
Danger of material damage if the wrong fluid is used for the clutch hydraulic system!
Danger of damage to property if too much Pentosin CHF 11 S is filled or if Pentosin comes into contact with
the coolant hoses when topping up or filling in!
Fill Pentosin CHF 11 S only into both supply tanks! •
To prevent overfilling and so overflowing, check the specifications in the clutch, fluid levels
description and observe them without fail! •
Multiple steering operations (manoeuvring) and/or actuating the clutch with the engine switched off
change the fluid level in the engine−compartment reservoir! Fluid level rises. In this case, the engine
must be run for approx. 20 seconds immediately prior to the fluid level check!
•
If coolant hoses come into contact with Pentosin, thoroughly clean them with water
IMMEDIATELY! •
Replace visibly swollen coolant hoses!
•
17. Top up hydraulic fluid Pentosin CHF 11 S in the front expansion tank (luggage compartment) and in the
engine compartment. Observe the prescribed procedure without fail ’ 30 Clutch: checking fluid levels.
Pentosin tank in the engine compartment
Front Pentosin tank
18. Bleed the clutch operation (clutch hydraulic system) ’ 30, 300107 Bleeding clutch operation.
996420, 996421, 996450, 996451, 996620, 996621, 996650, 996651
einordnung
Installation 675