Porsche 911 GT3 Cup MR Gen. II, Technical Manual

Page: 63 / 120

63 Version V2, 08/2020 Porsche 911 GT3 Cup MR Gen.II
Home
ELECTRICS | Endurance Wiring Loom
►
In the 911 GT3 Cup MR Gen.II, a fully integrated endurance wiring loom is used to connect all the
necessary systems. The 911 GT3 Cup MR Gen.II is equipped with the cockpit wiring harness and
the front wiring harness as standard. The rear wiring harness with connection options for air conditi-
6.2 Endurance Wiring Loom
NOTE
10 Nm
5 Nm
Before each event, all wiring harnesses must be checked for chafing
and the connectors for correct fitting.
NOTE
If the optionally available rear wiring loom is not used, a corresponding
dummy controller must be connected to the separation point (rear IO)
NOTE
The front IO control unit is located in the cars‘ front section. Weather
conditions can cause moisture to get into the connector. After driving
in wet conditions, the connector should be disconnected from the
control unit and a check completed for moisture ingress.