RF433 Bridge
POPE700700
POPE700717
Quick start:
1.
Connect the device to a USB port.
2.
If the LED flashes purple, connect to the open Wi-Fi
bridge433-XXXX
.
3.
Enter the IP address
192.168.4.1
in the browser bar.
4.
Set in the configuration mask your Wi-Fi, the IP address
and the communication port of your gateway.
(8000)
5.
Save the setting and activate the bridge.
6.
Install the RF433 application in the POPP Hub.
Configuration of the RF433 Bridge
1. Wi-Fi - settings:
SSID:
Enter the name of your home Wi-Fi.
Password:
Enter the password of your home Wi-Fi.
Scan:
Scan the environment for existing Wi-Fi networks
(If the page remains empty, please check your wireless connection to the bridge).
DHCP
: If checked, the IP address assigned by your router is used.
IP/Netmask:
Specify the IP address and network affiliation of the bridge.
Gateway:
Enter the IP address of your router.
2. SmartHome Gateway - Settings:
IP:
Enter the IP address of your Smart Home Gateway (POPP Hub).
Port:
Enter the communication port to your SmartHome Gateway.
Advanced settings:
Code send repeats:
Set the number of transmission repetitions of a command
(minimum 1; maximum 25). This may be necessary for some devices with poor
communication.
3. Save Settings:
Save the settings.
4. Activate Bridge:
Activate the 433Mhz bridge. The device restarts and then connects
to your Wi-Fi and SmartHome Gateway.
Reset Settings:
Resets the unit to factory settings.
LED indication:
